Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: labuda on December 30, 2007, 02:12:51 PM

Title: Mastercam X Lathe Question
Post by: labuda on December 30, 2007, 02:12:51 PM

Hi,
I just got a Wabeco lathe, and i'm playing around with mastercam X Lathe.
Weird thing: backplotting seems to work properly... see new-1
but when i simulate the machining, it offsets the tool and destroys my part. new-2 shows the program after one pass.

Title: Re: Mastercam X Lathe Question
Post by: MarkGerard363 on July 25, 2014, 12:45:27 PM

Sadly so far I have not been able to use not even a single of the G-Codes generated by Master-cam, it is most that obvious that when I run all my tool paths in the simulation on the computer with master cam every thing works perfectly! but when ever I transfer those G-Codes to my late computer! all hell brake loose! if you have any kind of success please share it with us! I hope that I can hear soon from some one here!