Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: fisherjim on December 30, 2007, 10:24:57 AM
-
Hi all,
Is there a code in Mach3 to clamp the max spindle speed when in CSS on a lathe?.
best regards
Jim
-
I have never found one, G50 S1000 is the normal format but G50 is scaling on Mach turn.
Graham.
-
Yes I guess it's going to be a macro job with a G or M prefix, I don't really want to strap the control down as some of my jobs are only 4mm to start with, hi.
Did you have a good Christmas?, I keep meaning to ring you about your Emco toolchanger macro, but when your up to your eyes in alligators............well you know.
Thanks for the reply,
Jim.