Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mrplace on December 25, 2007, 12:54:45 PM
-
Hello everyone. I just installed Mach 3 (Sherline Version) on my Sherline this weekend. I have went through the Setup Video Tutorials but I am having a problem.
When I use my up/down arrows both my Y and A axis move. From Mach 3 jog controller, I can use the mouse to press the A-axis button and I get no movement, only when pressing the Y-axis buttons do I get A movement.
Any comments on what may be happening and how to go about fixing it would be appreciated.
Ralph
Dallas, Texas
EDIT: Figured it out. The Y-Axis was slaved to the A-axis.
-
new to mach3 but also have sherline mill(5400)
check dir/step pins.
Kenneth
(D###, really need to look at dates)
-
;D
Brett
-
tried to attach a pic but it said it was already attached.
P.S. will (try) to look at dates :)
-
Rename your pic to something unique as the forum only allows a file name to be posted once.
Hood
-
Picture of what i have for the sherline mill(5400)
Thanks Hood