Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jimpinder on December 15, 2007, 03:29:54 PM
-
I've just got a web camera - an Advent ADE-A1 - and I,ve got it working on the computer - click MyComputer/Scanners and Cameras/USB Video Device - and up comes the picture.
I've got the plug-in installed on Mach3 Mill and Turn - but all I'm getting in "Unable to turn on camera" when I fire it up.
It doesn't, to me, seem to be pointing at the right driver, but I can't figure out how to change it.
Can anybody help???
-
After a morning of messing about, trying to alter the drivers, I got into it and discovered that the driver is the one named in the Mach3 window - and so would appear to be correct
As I say the camera works on the computer - Mach3 doesn't seem to be able to connect to it - any help out there???
-
I have sent you a personal message.
Brett
-
Brett - I don't know if you got time to look at this or not.
Anybody else got any input ???
Jim.
-
Hey Jim, you there?
Brett