Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Luis Torres on December 11, 2007, 07:19:38 PM
-
Help!!!!! I need to connect the plasma to the machine, dont know how, I only have one free pin , #1 , i havent find in mach manuals about this conection, is the same PWM, or the spindle?
Luis
-
Hi, Luis
Pin 1 is an output pin, You can use it to turn on your plasma cutter, Ports&Pins, Output Signals, Output#2, ("Check" Port#1, Pin #1, set Act/Low/High as Needed).
M3 will turn it on, M5 will turn it off, Need to use a small 5 volt relay(reed, miniature or Best a solid state relay}.
Hope this Helps, Chip
-
Ok, then I conect a wire to the pin #1, its only one wire? any other to ground or not? check disable spindle relays or uncheck? M3 and M5 in engine config relay control?
Certainly it helps... a lot, I have been all day looking for this...
Thanks
Luis
To Gnd. un-check
Chip