Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: beezerlm on December 04, 2007, 08:01:57 PM
-
OK guys here is the deal: ???
I am building a machine to dress shapes into a grinding wheel. I need to push a 14" dia grinding wheel to about 1000 rpm's. The wheel should not be under much load because the diamonds I am using are .020" radius tips and I am taking .002" per pass at 3 IPM. Looking for some suggestions for the most logical hook-up using a C11 BOB. What size and type of motor ???
Help is much appreciated! ;D