Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: wdp67 on December 03, 2007, 10:02:42 PM

Title: Need Some Help!!
Post by: wdp67 on December 03, 2007, 10:02:42 PM

Hi all, I downloaded V2.61 tonight and have it installed on a computer with no machine hooked up. I tried to edit a button script by pasting a script into the auto tool zero button. When I press the button I get an error message that says Compile error: Syntax error. I have this same script on my machine computer that has an older version of Mach3 and it works there. I am just glad I did not install the updated version there yet. Any ideas what I may be doing wrong?

Thanks
Walt

Title: Re: Need Some Help!!
Post by: Chaoticone on December 04, 2007, 07:05:58 AM

Walt, lots of the guys here are really good with VB. Might help if you will post the code.

Brett

Title: Re: Need Some Help!!
Post by: wdp67 on December 04, 2007, 12:28:39 PM

Thanks for the reply, but I figured it out and got it working, I deleted all the comments and it worked. Don't know why because the comments are in the script on the machine and it works, but at least I got it functioning!

Thanks a lot!!

Walt