Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Overloaded on December 03, 2007, 08:09:16 AM
-
Greetings,
Not sure if I should post here or in third party forum. Please advise for future posts.
I have a cnc4pc bob and am unsure of how to connect an Interinar and an Automation Direct driver to it.
The bob terminals are .... in# 5v in# 5v in# 5v in#.... and so on , 5v being commom.
The Interinar driver terminals are.... GND / STEP / DIR / ENABLE
The other driver is Automation Direct with terminals.. Step+ Step- / Dir+ Dir- / Enable+ Enable-
The bob looks to be OK the way it is for the AD driver but looks like I may have to move the jumper to 0v common for the Interinar driver.
I'm unsure and do not want to take any chances.
Any help would be much appreciated.
Thanks
-
All is good. I took a shot at it. With a little help from cnc4pc it works just fine.....NO SMOKE !
The "Enables" on this set-up are opposite of what I expected though.
Making chips soon.
Regards
-
Well, I can only wish you luck..
My mill is dead and I have no manuals for the wiring :(
I have purchased alot of the PC to CNC hardware already, but I wanted to use my servo motors, and I cannot find schematics to the motors :(
I can wire if I have a path... no path :(