Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jimmybondi on November 25, 2007, 03:32:56 AM
-
hi,
i'm looking for a possibility to switch the spindel pulleys within mach3.
my new mill has 6 gears and when i produce anything, its very uncomfortably
to switch to he settings screen and manual switch the pulley.
Maybe a personalized macro like M3.1 (to M3.6) is possible, but i'm not able to write a macro :-(
I don't mean a automatic recognised pulley by the speed-word within the gcode.
i mean just a command to tell mach3 that i switched the pulley.
can anyone help me ?
Thanks
Frank
-
Hi
Make a macro like M301.m1s for pulley 1
Write in the macro SetPulley(1)
save it
and so on for the rest
hope it helps you
-
Thanks - it works fine :-)
Frank