Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: toolman on November 22, 2007, 01:12:26 PM
-
Can anyone help me with a G100, I plug the wall adapter in the and only the CH-1 lights come on very dim is this correct .
-
Have you looked at the set up guide? Have you loaded the firmware?
http://www.machsupport.com/Downloads/machdownloads/G100_Set_Up_Guide_Rev.1_9-19-07.pdf
Brett
-
No I have not loaded firmware, can not load, what I am trying to find out is the unit working.
-
I'm not sure what one will do if it has no firmware loaded. All of my dir. lights come on brightly and a very dim analog out.
I have sent you a personal message.
Brett
-
hi did you get this figured out mine does the same thing
just the ch-1 lights on dim and then the green one comes on bright
when the firmware starts
please let me know as I cant get mine to turn the motors
have you got yours to move the motors at all
thanks