Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: marcello on November 13, 2007, 03:35:20 PM
-
hello everybody.
I'm using mach3 with grex g100 and I'm facing the following problem:
the feedrate override doesn't take effect while the cycle is started
only take effect after pressing (feed hold) and then (cycle start) buttons
-
Try redownloading and reinstalling the plug-in. Also make sue that no FRO on que isn't checked in general config. Let me know if this fixes it or not. I haven't got to play with the rex in a while and I won't get to any time soon.
Brett