Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: polaraligned on November 13, 2007, 11:39:52 AM
-
I have no automatic changer on my BOSS.
I tried M6 in the program, but the program just runs right past it.
M0 works, but I don't think this is the right way.
What is the proper way to suspend program execution so I can
change tools?
Thank You,
Scott
-
SCOTT, go to config page and look at teh top left side and check a box that says allow tool change/wait for cycle start
MACH will then SEE the M6 (;-) TP
-
Thank You,
I appreciate your response.
Scott