Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: marcello on November 09, 2007, 04:09:11 PM
-
hello everybody.
I'm facing the following two problem with milling machine using mach3 and grex.
1.the traveling speed(UNIT/MIN) do not change when the FRO change using analogue input of G100,but u can see it working offline (no device,check picture)
2. the mpg jog work for a few second before stop working i change to the second axis
it work for a seconds and stop working and the same for the 3th axis and after i cant change any axis using mpg but it's still working using arrow from screen.
thanks
Marcel khalaf.
-
Hi:
Is this with the newest G100 plugin, the FRO issue was updated about 1 week ago as I recall, have you downloaded a plugin lately?
Thanks
Art
-
Where does one find the new plugin??? I've installed the one at the Artsoft Download page but the installed version number "2.69" is unchanged.
-
Hi:
Someitmes the version number doesnt chnage on plugins, just download whats there..
Art