Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Shepard on November 09, 2007, 08:26:05 AM
-
I'm asking Mach's Keyway Wizard to cut .26 width with a 1/8 endmill but only get 1/8 slot. The gcode shows no change in y. I can't figure out what I'm doing wrong. Could you get me back on track? Thank you, Shepard
-
Shepard I just ran a simulation and what I saw was that it first cut a center .125 slot down the center, it then did a pocket of the slot width to clean it up and repeated until the depth of cut was reached. Did you actually run the file or just look at the code?
(;-) TP
-
I'm an idiot. Thank you. I had not let the file get to the pocket.
-
I cut 2 .250 wide key ways today and the machine left a ramp on the opisite side of the ramping of the program but the D.R.O. was going to the right count every time
any idea what is wrong