Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: rceebuilder on November 07, 2007, 06:53:38 PM
-
Lazycam beta does not add G41-G42 to the g-code if I don't add lead in/ out lines or circles. Is it mandatory to allow lead-in /out linesor circles to get G41-G42 codes ?
murat.
-
Hi, Murat.
I think that is the case, I asked about it some time back, Don't member the reason why it's that way though.
Thanks, Chip
-
I thing There is another bug. Lazycam adds G41 or 42 codes after the line where the endmill touch the workpiece. Below picture describes what I mean :
-
Hi.
I have also problem with the G41. Lcam generate some very strange code with small reverse movement over the desired lines so when i cut it cuts over my lines and back again. It is a very simple rektangel.
I will try it more today and coming back with the results but i have been struggling with this for a couple of days now.
Best regards.
Per
Here is the picture from Mach3 2.60