Machsupport Forum
Support => Forum suggestions and report forum problems. => Topic started by: richi2007 on November 06, 2007, 11:00:25 AM
-
Hi,
I have a problem when i turn on the computer and start Mach3.
For approx one minute the output on my two printer portts are freaking and i have to turn of them manually especialy LPT1 pin 16 is freaking and turns of when i start other outputs, but the other freaks as well.
When i have turned them of for a while it suddenly stops and everything works fine.
I have checked with the printer port analyser and it shows that the problem comes from the computer and not outer disturbans.
Could someone help me, please.
Thanks!
Rich