Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Peter44 on November 02, 2007, 10:31:38 AM

Title: M6 Toolchange not work with lathe
Post by: Peter44 on November 02, 2007, 10:31:38 AM

hello,
i can writhe on MDI or in the DIN code "M6 T3"
lathe ignorid this command,
i set Tool manualy too Tool 5
the screen show me Tool 5
i write "M6 T7"
the screen show me Tool 0, not 7

with the mill have i this Problem not, only with lathe

cu Peter

Title: Re: M6 Toolchange not work with lathe
Post by: Hood on November 02, 2007, 08:24:33 PM

In Mach turn you dont use M6, what you use is T0101, this is Tool 01 offset 01.

Hood