Machsupport Forum
Mach Discussion => Feature Requests => Topic started by: patrick71100 on November 01, 2007, 10:55:46 PM
-
most missed mach3 feature compared to commercial controls i have run,knob should go to 0 when starting a new program,as most crashes
are in the z axis usually tool offset problem or z value store from previous tool etc,enables operattor to stop motion and glance at z position
to see if it looks correct ,i got in that habbit after smashing a few drills due to sticky buttons on controls not zeroing z when setting tool heights,and also it would be great to have a start and e stop physical momentary? switches for safety,will the galil motion card support these
features take care guys patrick