Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: nobby on February 06, 2023, 05:33:56 PM
-
got some linear slidey doofers
want a little plasma table
first question, the linear sliders are solid round
the lengths are 700-800mm
is that ok for a tiddly plasma table?
i have another one as the loose one in the pic
the plan is to widen the lower twin rails parts
to utilise the length of the y axis
then chop down the other one for a z
what length do i chop it too, do i need more than 50mm travel for a plasma?
any one near west london fancy doing some machining