Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: SROPLASMA on January 24, 2023, 08:18:49 PM
-
Hi there,
I am working on setting up Mach 3 on a 3 axis plasma cutter. Everything is working fine except for the Z axis. It will only move in the negative direction. This includes both jogging and MDI moves. The X and Y axes work fine in both directions. Soft limits are temporarily set to 0 min and 0 max for all three axes so I don't think that is the problem. I have tried two different stepper drivers and two different stepper motors on the Z with no luck. Could I be missing something in the configurations? Any help would be appreciated. Thanks, Steve
-
To clarify, if the motor coil wiring is swapped, the Z axis will only move in the up direction.
-
This problem can be caused by either the direction connection to the driver missing or possibly the direction signal pulse edge timing relative to the step pulse being wrong.
-
Thanks for the response. Hardware issue. I tried a third stepper controller and that worked. Thanks again.
-
Excellent.