Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: personale@lvlsystem.it on January 20, 2023, 09:01:46 AM
-
Good morning everyone !
I'm using Mach3 with a PC that has 2 ethernet cards. One of the 2 is used for the CS-LAB controller while the other is used for ordinary network management and for sending files to the PC. The 2 boards are in conflict with each other, how can I fix it? If I disconnect the second card and use a Wifi, everything works fine. Thank you
-
The ethernet card for CS-lab controller and the controller should have manually assigned IP addresses of another subnet and without a default gateway (leave blank).