Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: stirling on November 01, 2007, 01:31:15 PM

Title: where did CV go?
Post by: stirling on November 01, 2007, 01:31:15 PM

V2.56.1

So I'm using the machine all morning and all is well. :)

I resume this afternoon and CV is gone - disappeared - ceased to be - awol. Jerky toolpaths enough to shake the thing to bits. Not only that but I'm getting limits going off all over the place.  >:(

I look everywhere for what's changed. Can't find anything - so then I give up and just do a re-install. Same profile though and hey presto everything's immediately cool again  :)

Is it me or is Mach getting a little Kellogs these days? ???