Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: DanieGouws on December 29, 2022, 04:12:16 AM

Title: Mach3 Not saving the current tool number at shut-down
Post by: DanieGouws on December 29, 2022, 04:12:16 AM

Hi Everybody,

I run Mach3 on an OMNI router with a ATC spindle. All works fine except the system function, current tool number, is not stored during shut-down. I assume all system functions would be saved in the XML configuration file? What am I doing wrong?

Kind regards and thank you

Danie

Title: Re: Mach3 Not saving the current tool number at shut-down
Post by: TPS on December 29, 2022, 06:17:22 AM

try:

Config -> General Config -> Axis DRO properties -> Tool Selection persistent

Title: Re: Mach3 Not saving the current tool number at shut-down
Post by: DanieGouws on December 29, 2022, 06:56:20 AM

Thank you very much!

Regards Danie