Machsupport Forum
Mach Discussion => Mach Screens => Topic started by: Graham Waterworth on April 11, 2006, 11:13:39 AM
-
Hi,
has any body got a turning screen set that looks like the fanuc 6T,11T or 18iT, all the Mach ones I have seen so far are way too complicated and over cluttered. A nice basic screen is all I want.
Thanks
Graham.
-
Thats a good idea, Can you post some screen captures of each Fanuc page that you want emulated.
I wouldn't have a clue what they looked like, in order to emulate them.
I might get in trouble if I use the word "copy" instead of "emulate."
-
can any one tell me how to see or download on of these screens
Barry
-
I am looking for a simple screen to suit a plasma cutting XY table
Barry
-
Barry, there is a few screens in this section of the forum, though they are all at experimantal stage. You can edit the current screens with the screen designer found in the mach folder of your installation. Its not too hard to use as you will see. Let us know how you go.
-
Did anything ever transpire on this request?
-
No, it never happened but I did do one for education that may be worth a look.
https://www.machsupport.com/forum/index.php?topic=41385.0 (https://www.machsupport.com/forum/index.php?topic=41385.0)
-
Hi chuck767,
I notice that you have posts on the Mach4 Disscussion board. If you are indeed using Mach4 or wishing to, then this board will be
of no help to you. This board concerns itself with Mach3 screens and its screen editor, none of which apply to Mach4.
Mach4 runs as Mach4GUI.exe and so the screen is editable without recourse to a separate program as is the case with Mach3. Indeed the
ease and flexibility with which you can edit the screen and its underlying scripts is perhaps the single biggest and most useful change from
Mach3 to Mach4.
Craig