Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bigtimeb on September 08, 2022, 06:38:49 PM
-
Hi all,
This is my first post. I am very green to Mach 3 and VB. I have a new machine with a C2U6 controller. I'm attempting to fix a corner probing script that calls on G31. I have heard through the grapevine that this board can only handle one G31 call at a time. I can not call a "G31 X" & X1 & "Y" & Y1. I am attempting to call each G31 seperate. I managed to get the script to function and the probe to trigger. The issue im having now is that I am not getting any consistency with it returning to zero. sometimes it's dead on, then if I reprobe the same corner it will be off on the Y axis 20 thou or more. Any help would be awesome! TIA