Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kolias on August 10, 2022, 01:32:32 PM

Title: Mach3 Tool Display Screen Circles
Post by: kolias on August 10, 2022, 01:32:32 PM

Got my first object drawn and simulated a run in my CAD program and works well. Now I got the NC code from it and ask Mach3 to open it and I see these 2 circles which are not part of my object and don’t know what they are. In the attached picture my object is at the lower left from the origin.

I remember few years back I had something similar and correct it by changing in the General Config the “IJ Mode” to absolute but this did nothing to my problem.

Any idea why these circles?

Title: Re: Mach3 Tool Display Screen Circles
Post by: kolias on August 10, 2022, 02:58:57 PM

Sorry about this folks, the problem was with my CAD program where I selected circle and chain operations for the same subject. Now all is good