Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: frapo on July 12, 2022, 03:42:40 AM

Title: reverse axe direction
Post by: frapo on July 12, 2022, 03:42:40 AM

Hi
how can i reverse the axe direction for my mini lathe.
The -z and the +z runs the same direction and also the -x and the +x runs the same direction.

Title: Re: reverse axe direction
Post by: Greekart on July 12, 2022, 04:03:38 AM

Quote from: frapo on July 12, 2022, 03:42:40 AM

Hi
how can i reverse the axe direction for my mini lathe.
The -z and the +z runs the same direction and also the -x and the +x runs the same direction.

Go to Configure - Control - Motors and down, between Backlash and Enable delay is a tick for reverse.

Title: Re: reverse axe direction
Post by: Greekart on July 12, 2022, 04:04:27 AM

Or you mean about keyboard control??

If yes go to Configure - Plugins - Keyboard and change there.

Title: Re: reverse axe direction
Post by: frapo on July 12, 2022, 04:14:29 AM

Just try this and no change.

Title: Re: reverse axe direction
Post by: Greekart on July 12, 2022, 04:17:57 AM

Quote from: frapo on July 12, 2022, 04:14:29 AM

Just try this and no change.

What controller you use, check the controller plugin it may need to change it there. Or maybe you have something wired wrong and work only one direction..

Title: Re: reverse axe direction
Post by: frapo on July 12, 2022, 05:01:03 AM

In mach3 all was working fine,i use  uc100 motion controller.

Title: Re: reverse axe direction
Post by: frapo on July 12, 2022, 06:19:05 AM

Solved,my direction pin numbers were wrong, sorry for the trouble greekart thanks anyway.