Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: gldfshrdr on March 25, 2022, 06:27:03 PM
-
Hey guys. I've setup for surface probing. But the DRO is intermittent. When I hook up my meter to pin 15 on the bob,(cnc4pc) and the -V on the Z axis power supply I get consistent 1 ohm. But the DRO blinks couple of times and stops. A retouch does it again and stops.
Mach3
CNC4PC bob
ESS
Win10
I've attached the Script I used.