Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: gldfshrdr on December 08, 2021, 11:47:39 AM

Title: Mach3 has control but steppers run one direction only....help!
Post by: gldfshrdr on December 08, 2021, 11:47:39 AM
CNC setup.

Windows 10, Mach3, ESS Smoothstepper, (CNC4PC) C25S BOB and DIV-268N-5A drivers (3ea for X,Y,Z only), Stepper motors are 4 wire.

Mach3 Config in outputs:
X axis      Y axis      Z axis
Pul+ pin 2           Pul+ pin 4           Pul+ pin 6
Dir+ pin 3           Dir+ pin 5           Dir+ pin 7
Pul- pin GND   Pul- pin GND   Pul- pin GND
Dir- pin GND   Dir- pin GND   Dir- pin GND

Dir Low active is green checked for all axis.

Drivers have no connection to Enable+ or - ?

Has anyone else used the above drivers?

Thanks......dt