Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ironman123 on October 25, 2021, 10:07:12 PM
-
I am not sure if this is the place for this or not but here it is:
I have a HF 47158 Micro Mill that I bought in 2003 and added 4 axis CNC controls to it. It has a small Table (9.375x5.375 inches) I can only get a work area 5.5 x 3 inches on it.
I am using the Mach3 Version 3.042.029.
When I click on machine coordinates, it takes off to lower left, past my table and locks up my y axis stepper. I need to set the machine xy to my work area xy start position. I have not been able to do it. Assistance will be greatly appreciated.
Thank you,
Ray