Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jfiggs on October 18, 2021, 04:17:31 PM
-
So I purchased a small laser attachment from china, it has a plug with 3 wire attachment which is labeled PVV,GND,PWM. The power is 12 volts dc to terminals PVV and GND. my break out board probably would use terminals 1 and 17 from what I read elsewhere. So my question is will I be able to tie the ground from the breakout board to the same ground of the laser power supply and attach BB terminal 17 to PWM? Thanks for any help!
-
So my question is will I be able to tie the ground from the breakout board to the same ground of the laser power supply and attach BB terminal 17 to PWM?
Yes.
Tweakie.