Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kf2qd on October 05, 2021, 09:23:14 PM

Title: Custom Control Panel for Mach3 (and maybe Mach4)
Post by: kf2qd on October 05, 2021, 09:23:14 PM

Started playing with an Arduino Micro controller. It can be programmed to function as a keyboard device. About any keyboard key code can be sent, the board has enough pins to handle a Cycle Start button, A FeedHold button, a Stop button, Jog Keys, Jog Mode, Jog Enable toggle and others. AND No Special Drivers needed. Plugs into a USB port, is programmed using Arduino.

Just a little something to think about.

Title: Re: Custom Control Panel for Mach3 (and maybe Mach4)
Post by: Tweakie.CNC on October 06, 2021, 03:10:16 AM

Good thinking  ;)

Tweakie.