Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: i_am_joe on October 01, 2021, 12:01:38 PM

Title: Using safe z on stop button.... gcode does not resume at correct height
Post by: i_am_joe on October 01, 2021, 12:01:38 PM
Hi everyone.
I'm using the safe z height in mach3 when I press the stop button.
When I click "cycle start" to resume running my gcode. It runs at the safe z height and not the depth of the tool path. Any suggestions on how to change this?
Thanks very much