Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Toshio.K on September 13, 2021, 07:23:46 AM
-
Hello everyone.
The INDEX LED does not blink. Please tell me the solution.
I am,
The Hall IC DN6851-A is connected to the BOB input terminal (Port3 # 10).
The setting of Mach4 maps Port3 # 10 to INDEX.
You can check the On / Off of Port3 # 10, but the INDEX LED in the red frame does not blink.
Can anyone please tell me the solution?
Thanking you in advance.
-
Have you checked the output of the sensor with a voltmeter? The DN6851-A hall effect sensor you have used is an alternating magnetic field type. The magnetic field it sees needs to change between as least -20 mT to +20 mT. In other words, it needs to see both the North and South pole of the magnet to operate.
-
Hello Mr.MN300.
> Have you checked the output of the sensor with a voltmeter?
Yes, I confirmed with a tester.
On / Off.
And Port3 # 10 on the diagnostic tab flashes.
Please look at the photo.
Is my Mach4 setting correct?