Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Michaelc on September 12, 2021, 09:38:04 AM
-
Hi, most of you know that the most expensive thing apart from the machine is the stepper motor drives, power units, Bob etc. I have three cnc machines. A milling machine, a router and a lathe. I would like to run the all from the same Bob etc. Should say I don’t wish to run them at the same time. To keep things easy, is it possible to run more then one copy of Mach3 on a single pc. I can then just plug in the motor signal cables into the correct machine and run it. Anyone out there no the answer. Thanks.
-
You can run as many Mach3 Profiles from one PC as you wish.
Tweakie.
-
Thanks. All good then
-
All good ;)
Tweakie.