Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: drew on October 17, 2007, 03:39:55 PM
-
Is there a DRO for the offset number called after the tool number in Mach lathe?
The code 'T0313' reports tool DRO as 3 and does offset by the values in 13.
I would like to add a DRO for the offset used but I didn't see it in the list.
Thanks Drew
-
bump
-
I dont think there is a DRO for this and by coincidence I was looking for this exact same thing a few days ago. I have asked Brian if he knows of one but as he was away on a job he couldnt look in the code. Hopefully he will have time soon, after he recouperates from his travels :)
Hood