Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: Hurricane2017 on August 17, 2021, 02:38:04 PM
-
Hello,
I have spent the last several hours trawling the other similar posts about Pokeys57CNV and mach4 Configuration issues but none of those solutions help unfortunately!
I recently fitted a lathe with the PoKeys57cnc and had everything working well in Mach3, I decided to upgrade to Mach4 for the threading capability.
Unfortunately, I cannot configure the 0-10v output (pin 17) to control the spindle speed. I have read all the literature and searched dozens of posts but I can't get it to output any voltage at all.
As I mentioned, this speed control is working perfectly with Mach3.
Any help would be greatly appriciated,
Cheers,
Aidan