Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: MyCNCNightmare on August 10, 2021, 05:14:06 PM

Title: Trouble homing master/slave axis and other possible issues. Need help.
Post by: MyCNCNightmare on August 10, 2021, 05:14:06 PM
Problem:  Unable to get master (y) & slave (a) axis to home together.  The slave will only run with the master, never separate.  So I am unable to reliably square my gantry when homing the machine.

While trying a few things in the "edit button script" I noticed some things that didn't match up to what I had seen in other posts.

DoButton( 24 ) - Controlled Z axis
DoButton( 23 ) - Controlled Y axis
DoButton( 22 ) - Controlled X axis
DoButton( 25 ) - Did nothing, however I had to physically trip the homing switch on the A axis <or> hit reset to be able to REF ALL again

DoOEMButton(133)
DoOEMButton(134)
DoOEMButton(135)

I've seen other forum posts where the DoButton codes were as follows...
24 - Z
23 - X
22 - Y
25 - A

Everything appears to be connected properly and my ports/pins are set correctly.  Home w/master axis is unchecked in general config tab.

Software: Mach3
Motion Controller: Digital Dream UC300
https://www.nvcnc.net/uc300.html

Any help is appreciated.
Modify message
Title: Re: Trouble homing master/slave axis and other possible issues. Need help.
Post by: Tweakie.CNC on August 10, 2021, 10:59:16 PM
Hi,

Due to their license violation this forum does not support Novusun products. You need to contact the manufacturer / supplier of your Digital Dream controller and seek their assistance with any Mach3 settings isues you may have.

Tweakie.