Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: copperheadmetals on August 04, 2021, 08:21:18 AM
-
When I first open Mach4 no gcode loaded, set it to jog incrementally for 1" X and Y will move 1" and the DRO will show 1.00. When I move the X axis 1" DRO will show 5". I'm not sure how long it has been this way but I replaced the limit switch for the probe and needed the offset for my post and noticed it was clearly off. any idea where it is getting this info? Ive been told multipliers but ive looked over general config and in ESS config and see nothing.