Machsupport Forum

Third party software and hardware support forums. => HiCON Motion Controller => Topic started by: northwoodsproducts on July 03, 2021, 09:57:14 AM

Title: Very Slow Homing on all axis X,Y,Z
Post by: northwoodsproducts on July 03, 2021, 09:57:14 AM

Mach4
Hicon Integra 7866
60X120 table build

When I home all the axis homing starts Z then X the Y
No matter what percentage I input in Mach4 for homing all axis move at an excruciatingly slow pace towards the home location.

Is there something in Mach4 or Hicon that I can change to speed up my homing?

Is there something I need to check to facilitate my ability to change homing speed in Mach4 at the homing and limits tab?