Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: rhtuttle on May 12, 2021, 12:10:27 PM
-
Has anyone used the above combination? I had a pmdx411, gecko g540 and mc60 working on my lathe. Needed more outputs and switched to Pokey57CNC. The g540 had 3 wires to the mc60, the +10v, common and 0-10v to regulate the spindle speed.
I am electrically illiterate and cannot figure out how to wire the pokeys board to the same mc60 speed controller. I have the white connected to pokeys 0-10v output but don't know where the black and red wires should be connected. Any guidance would be greatly appreciated.
TIA
RT
-
Solved. I had it wored correctly but one of my solder joints had broken under some shrink wrap.