Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: IGoodwin on May 06, 2021, 09:03:03 AM
-
Mach 3
Hi there...I've been looking for the correct port address to use for my USB controller....all the blogs I read mention the printer port address but I cannot find anything on USB settings.
Can any helps please?
Cheers
Iain
-
usb Controller will Need a plugin.
-
So you don’t enter any settings for the port number if it’s usb? The driver takes care of the address? Cheers Iain
-
there is no "global" answer for this, it is allways depending on your Controller.
witch Controller are you using?
any documentation avaliable?
-
So you don’t enter any settings for the port number if it’s usb? The driver takes care of the address? Cheers Iain
No, no port address needed with a USB controller.