Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: Mauri on April 14, 2021, 12:20:40 AM

Title: Mach4-X3-HiCON.m4prof
Post by: Mauri on April 14, 2021, 12:20:40 AM

Steve, (smurph)
As requested the Mach4-X3-HiCON.m4prof is attached.
Regards,
Mauri

Title: Re: Mach4-X3-HiCON.m4prof
Post by: Mauri on April 14, 2021, 04:41:51 PM

Steve,
The file below has my Mach4 Input and Output Signal setting for HiCON.
These work just fine for example Mach4 V3804 the spindle starts just fine.
I have used the same settings on many Mach4 Programs for many years and have machined many carvings all without issue.
But now it will not start.
Regards,
Mauri.