Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Strangar on April 10, 2021, 03:02:34 PM
-
I am having issues with my Soft Limits.
My machine is capable of
X - 101.5"
Y - 54"
Z - 12.5"
I have set my limits in Motor Home/Soft Limits to these values
X - Max:101.5 - Min:0
Y - Max: 54 - Min:0
Z - Max: 0 - Min: -12.5
Y and Z soft limits work perfectly.
The issues is that I can turn on my Soft Limits when my X is lower than 73.63" and it works all the way up to 101.5 when shuttling. The issue is when my CNC has a X value greater than 73.63" and I turn off Soft Limits I cannot turn it back on until I am under 73.63". Also if I have a job that is larger than 73.63" I cannot run it with soft limits enabled. I have been running without soft limits for a wile and would like to get this issue resolved.
-
softlimits are allways based to machine coords. so Switch to achine coords to check the values.
-
Sorry, I guess that I did not mention that everything is in Machine Coordinates.