Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jackrusse11 on April 04, 2021, 01:07:54 PM
-
Evening all.
I'm fairly new to Mach3 and specifically the turn version. I have come across a little problem.
I added a few buttons onto the standard lathe screenset (1024.lset).
If I now point my mouse to the Engine configuration / ports & pins; 'MILL OPTIONS' is there instead of 'TURN OPTIONS'.
How this manifested itself was that (all of a sudden), I realised the X axis was cutting on the radius and not the diameter as I had set. Despite showing 'diameter mode' on the screen.
If you look at the two screen grabs, you'll see the difference.
Any help would be wonderful.
Kind regards
Jack
-
what screeneditor did you use to make the changes?
and the modified file set is still ...lset ?
-
Hello,
Many thanks for the quick reply. I used 'screen4'. Yes, it is still 1024.lset. Everything works perfectly, except the tab shows mill options.
Cheers.
-
try to use machscreen.
https://kd-dietz.com/download/MachScreenV1.72a.exe
never had a Problem like this