Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kaminco on April 03, 2021, 10:24:38 AM

Title: Violentlt fast "to home movement".
Post by: kaminco on April 03, 2021, 10:24:38 AM

I just purchased the lisence for M3.

Now my gantry moves super fast to the home position when I push go to zero button.

My table is a dual drive home built unit using a a G540 controller.

In addition, I was able to make the table cut the road runner, but the part was super small.

It seems my problem started after the liscencxe install.

Any suggestions?  Please respond like I'm 10 (actually 53).  I'm very new to this.  I'm a nuckle drtagging fabricator with enough computer knowledge to be dagerous.

Here is a vid of what I am so far capable of.
https://youtu.be/6W6_TBVMNW0

Thank you

Kirk

Title: Re: Violentlt fast "to home movement".
Post by: TPS on April 03, 2021, 11:27:58 AM

i would suspect metric and imperial Units mixed up.