Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: brent48 on March 27, 2021, 07:31:01 PM

Title: setting up slave axis
Post by: brent48 on March 27, 2021, 07:31:01 PM

How do I get the axis to move after the following message appears?
Slaved axis is unaligned! Home the machine before jogging!
None of the axis will work until I take the slaved axis off, but then I still can't home it as I don't have limit switches.
I'm also using POKeys57CNC with mach4
Any help out there??
thank you

Title: Re: setting up slave axis
Post by: GOOMBA on March 31, 2021, 02:28:19 PM

Try using home in place under Configure > Control > Homing / Softlimits
My honest advice though.... get home switches.
Consistency is a wonderful thing when troubleshooting :)