Machsupport Forum

Mach Discussion => Mach4 General Discussion => Topic started by: KentCNC on March 25, 2021, 01:58:03 PM

Title: ShuttlePro Losing Setup
Post by: KentCNC on March 25, 2021, 01:58:03 PM

My ShuttlePro is losing setup information. I use it to jog the x, y, and z. I use the inner wheel to jog in small increments (0.001"). I set the increments using the Incremental Jog Step on the Jogging tab. This along with the key mapping sometimes is not saved between closing and opening Mach. Unfortunately, I first noticed this when trying to check the z-zero position. I had the z- jogged close to the workpiece and was going to gauge the setting by sliding a piece of paper back and forth under the bit will stepping down in 0.001" increments. However, the increment was reset to 1". Needless to say, my bit exploded when it took that 1" step into the workpiece.

I assume this is a bug???

Title: Re: ShuttlePro Losing Setup
Post by: GOOMBA on March 29, 2021, 11:10:52 AM

What build of MACH are you running?

Title: Re: ShuttlePro Losing Setup
Post by: KentCNC on March 29, 2021, 11:58:09 AM

Mach4 Build 4612 and ESS 272.

Title: Re: ShuttlePro Losing Setup
Post by: smurph on March 29, 2021, 01:16:16 PM

Yeah, this caught me too.  At first, I just thought it was a problem with my profile.  But I was able to reproduce losing the configuration.  It is fixed it in build 4700.

Steve

Title: Re: ShuttlePro Losing Setup
Post by: KentCNC on March 29, 2021, 03:46:58 PM

Fantastic! Thanks for the info.

Title: Re: ShuttlePro Losing Setup
Post by: KentCNC on March 29, 2021, 09:15:38 PM

Is build 4700 available? I only see 4612.

Title: Re: ShuttlePro Losing Setup
Post by: smurph on March 30, 2021, 01:03:07 PM

The development versions. 

http://www.machsupport.com/ftp/Mach4/DevlopmentVersions/