Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: micknashdev on March 17, 2021, 03:41:58 PM

Title: jogging problems after installing a new/old PC
Post by: micknashdev on March 17, 2021, 03:41:58 PM

Hi all,
I have just installed another old XP pc to drive my Denford Orac lathe. I am still on the demo version. After installing the new PC i can only seem to jog with the incremental button lit, and only moves the incremental distance or rapid with the shift button pressed.
Before I could jog with just the JOG button lit and could jog as far as I wanted.
What should I enable/disable to get back normal jog control please.
Mick.

Title: Re: jogging problems after installing a new/old PC
Post by: TPS on March 18, 2021, 02:07:21 AM

use the Tab Key and then Switch to continious mode.