Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Fred_evans on March 04, 2021, 04:28:33 AM
-
Hello Chaps,
I was wondering if Mach 3 will control a chinese K40 laser?
can any one help??
regards
fred evans
-
It can if you rip out the existing control board and replace it with one that is Mach3 compatable.
Tweakie.
-
there is a Software called K40 Whisperer.
witch might be suitable, just a thought.
-
thanks tweakie--
yes I am using k40 whisperer - just thought that I could use mach
but thanks for your answer
regards from a nice warm south africa
fred
-
Hi Fred,
Don't rub it in, it's Brass Monkeys here in London :(
Tweakie.